The Peaks section in the Measurements tab allows you The Spectrum Analyzer computes peaks from the portion of the input signal that is currently on display in the scope, and the Peaks panel shows the peak values and the frequencies at which they occur. When you click on the Peak Finder button in the Measurements tab of the Spectrum Analyzer, an arrow appears on the plot at each maxima and a Peaks panel appears at the bottom of the scope window. To enable the Time Resolution (s), selectĬompute and display peak values in the scope display. Resolution (s) to Auto or enter a positive In the Time Options section, set the Time Scope Window UseĬlick the Spectrogram tab on the Spectrum Analyzer To enable this property, set ViewType to "spectrogram" or Several spectral estimates areĬombined into one spectrogram line to obtain the desired time resolution. Then the specified time resolution value must be equal to or larger than the minimumĪttainable time resolution which is defined by 1/RBW. TimeResolutionSource are set to "property", RBW becomes the main control and the time resolution is set 1/RBW s. TimeResolutionSource is set to "auto", then Then time resolution becomes the main control and RBW is set to 1/ TimeResolution Hz. TimeResolutionSource is set to "property", "auto", then RBW is set such that there are 1024 RBW intervals in When you set RBWSource and TimeResolutionSource to Source of the time resolution of each spectrogram line, specified as either Enhancements to Data Cursor Measurements.Support for waveform cursors in spectrogram mode.New fields on Spectrum Analyzer status bar. ![]()
0 Comments
Leave a Reply. |